If you want to squeeze a few more files on your 1.44MB (nominally 2MB) floppies, and save a few pennies in the process, 2M will help. We are ask already the company which one is buils this machine for upgrade,but is allmost to expencive,the machine is 10 years old,so for now I must work like it is.FREE SOFTWARE FOR DOS Disk Utils 2 Free Software for DOSĢM Format floppies to higher capacities. You are right about that!This is real old stuff,becouse today almost no one use floppy anymore,but I need this type of floppy at my work.I must format 1.44 floppy to 720 kb,becouse this CNC machine only accept this disk and I can't buy this type of disk anymore,so if I like to made a program for machine I need this format. ![]() And you get twice the space on your floppies (transfer twice as much) and no need to scotch tape the other hole (what an annoyance). Personally, I'd opt for upgrading the drive in the CNC controller if possible though - it's supported by BIOS, OS and all on the CNC machine (unlike say, using USB flash drives instead or such), and there's no need to downgrade your XP or look for specific software to write to older floppies and such (every PC with a floppy drive these days supports 'em). Lots of machine shop tools like that run plain old DOS on very old hardware (most of the time 486 and older, and a bit of "newer" P1's). ![]() ![]() I would normally 100% agree with you on that point - old, obsolete legacy junk I don't want near any of my systems.īut it's a CNC machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |